Choose your installation guide below. Whether you're fitting an EVO kit, patterned frame protection, or Shush Tape, select your product to view the step-by-step video and application instructions for a fast, bubble-free finish.
Note: Certain finishes (especially fluoro colors) may fade naturally over time; protected areas may retain their original vibrance compared to exposed paint.
EVO kits require a wet application using a water spray to float and align the film perfectly into place. Once positioned and squeegeed dry, apply gentle heat with a hairdryer around edges and complex contours to activate the adhesive and secure a seamless finish.
This guide applies to all patterned kits as well as original clear frame protection (non-EVO). These kits are applied dry directly to a clean frame, so no water spray is required. Use a hairdryer on low heat as you work to make the film flexible, contouring it around bends for a tight, bubble-free bond.
Frame Kit Installation
Frame Kit Removal
Clean and degrease the target area thoroughly before applying. Press down firmly along the chainstay or frame surface, applying smooth pressure from the center outwards to eliminate air pockets and secure maximum adhesion.
SHUSH Chainstay Protector Installation
SHUSH Downtube Protector Installation
